Documents
Change the Device IP Address
Before configuring the device, set the PC IP to the same subnet as the device; the IP address must be different.
New devices ship with default IPs starting at 192.168.168.200 and incrementing; set the PC IP to 192.168.168.100.
Check the network connection: when the settings are done, type cmd in the Windows “Run” box to open a command window and run ping 192.168.168.200. If you get replies, the PC and the device are connected.
- Open the PC network connection settings → right-click the connected network adapter and choose Properties.

- In the “Ethernet Properties” window that opens, double-click “Internet Protocol Version 4 (TCP/IPv4)”.

- In the “Internet Protocol Version 4 (TCP/IPv4) Properties” window, select “Use the following IP address” and set: IP address 192.168.168.100, subnet mask 255.255.0.0, default gateway 192.168.168.1.

Double-click the installed “Visual Cloud Management Platform” application “” to open the login screen. Enter the IP 192.168.168.200, the default account admin, and leave the password blank.

If login fails, check in this order: ① whether the PC IP and the device are on the same subnet; ② whether the device network port LINK LED is normal; ③ whether the PC firewall / antivirus software is blocking; ④ whether the device IP was changed on site (if so, log in with the new IP). See “Login troubleshooting” in “Getting Started” for details.

Note: you can change the IP in two ways — manually, one IP at a time, or in bulk with one click. Choose according to the site. Both methods change the device IP; plan the IP addresses and never create IP conflicts.
1. Manual change
① Click the “大屏配置(Video Wall Configuration)” button in the software.

Configuration tool login password: admin123

In the window that opens, click “Search” to find the board IPs online on the local network. (Note: a white IP icon means the connection is normal; a red icon means the board is on a different subnet from the PC or the IP conflicts.)

④ Click the small gear “” after a searched board IP → on the “Settings” page choose “Network Settings” → on the “Network Settings” page you can change the device network parameters: IP address, subnet mask, gateway → click “Save”; the board restarts automatically. (For cross-subnet communication, enter an IP of another subnet in the multi-IP list; up to 3 IPs can be set.)


Every board is changed the same way: change each board IP to the required subnet, then redo output mapping. When output mapping is done, reopen the software and log in with the new main control IP. (Note: after changing the device IP you must redo output mapping; see “Output Mapping” below.)
Important: After changing the board IPs, change the PC IP to the new subnet as well, and you must reconfigure output mapping (see “2. Output Mapping” below). Otherwise the software cannot connect to the device and the spliced video wall image is scrambled.
2. Change IPs in bulk
① Click the “一键修改 IP(Bulk IP Change)” button “”. On the page that opens, enter the starting IP, subnet mask and gateway, select the devices to change (or select all) and click “Start Configuration”; the software then assigns network parameters to each board in sequence from the starting IP.


② When finished, redo output mapping. Then reopen the software and log in with the new main control IP. (Note: after changing the device IP you must redo output mapping; see “Output Mapping” below.)
Did this page help you?One line of feedback helps us keep the steps accurate.