Documents
Common Troubleshooting
- Cannot log in to the Visual Cloud Management Platform software
-
Network cable and LINK LED: reseat the cable and confirm the port LED blinks
-
IP subnet: check that the PC IP and the main control IP are on the same subnet
-
Temporarily disable all firewall and antivirus software
-
Ping test: run ping against the device IP in a cmd window to check connectivity
- Signal added successfully, but the video wall is black
-
HDMI signals: confirm the source is powered on and the cable is intact;
-
Monitoring signals: confirm the board and the camera are on the same subnet; verify the user name, password and RTSP port; confirm the camera encoding is H.264/H.265;
- Monitoring video stutters or shows artifacts
- Use a gigabit switch and Cat5e or better cabling; reduce the camera bitrate appropriately.
- ONVIF cannot find the camera
-
Log in to the camera web interface, enable the ONVIF service and create a new ONVIF account;
-
The device and the camera must be on the same LAN subnet; disable the firewall.
- No preview in the monitoring software
- IPC preview requires an optional IPC preview board; without that hardware the software has no preview, which does not affect decoding to the video wall.
- PTZ dome camera cannot be controlled
- Confirm the dome camera was added using the ONVIF protocol; cameras added via RTSP do not support PTZ control.
- Display is misaligned after mapping
-
Confirm the physical cabling of the video wall is correct;
-
Complete the mapping drag, click Save, and be sure to restart the device;
-
After changing the board IP, the output mapping must be redone.
- No audio output
-
The input signal must be a combined audio/video signal;
-
Click to enable audio on the video wall screen of the Visual Cloud Management Platform;
-
Connect the 3.5 mm audio output to a powered speaker and adjust the volume slider.
- Cases where self-repair is prohibited
In any of the following cases, do not open the chassis for repair:
Power cord or plug damaged, aged or broken;
Debris or liquid has entered the chassis;
The device has been exposed to rain or moisture;
Dropping or impact has damaged or deformed the chassis;
Smoke, abnormal noise, burning smell or other anomalies.
- Conditions for professional repair and the repair request process
If the fault cannot be recovered by normal operation, consult the relevant technical staff.
Contact the manufacturer or an authorized dealer and describe the fault symptoms, the operating environment and what was done.
The manufacturer will assign a qualified service technician to inspect and repair the device; third-party unauthorized repair is prohibited.
- Prohibited actions during a fault
While the device is faulty, do not force it on or repeat power-on tests, to avoid extending the damage.
Do not open the device, replace components or modify circuits yourself.
Do not connect further loads to a faulty device, to prevent fire and electric shock.
Did this page help you?One line of feedback helps us keep the steps accurate.