Documents
Getting Started
Quick Start: Go Live in 5 Steps (Must-Read for New Users)
This chapter helps first-time users complete the fastest path to “signals on the wall”. Follow the order below when commissioning and do not skip steps. If an operation fails, check “Login troubleshooting” in this chapter and see “Common Troubleshooting”.
Preparation: tools and environment (have everything ready before you start)
- Tools you need:
- Cloud integrated processor (power cord included)
- Video wall and matching video cables (HDMI, etc.)
- Commissioning PC (Windows 10/11)
- Network cables (Cat5e or above), gigabit switch (when there are many devices)
- Environment and network notes:
- Disable the PC firewall and antivirus software (or add the software to the trusted list) so that device discovery is not blocked; if the system shows an unsafe warning, it is safe to allow.
- Downloading the software requires network access: download and install the software while the PC can still reach the internet, then change the PC IP for commissioning. Once the IP is changed, the PC leaves its original network and can no longer download.
- Confirm the device is powered on and the power LED (PW) is steady on.
Step 1 Download and install the software (complete this before changing the PC IP)
Open www.gshelp.top in a browser, select the cloud processor entry, choose “Processor Software”, download the installer and install it. Saving the installer to the PC desktop is recommended.
Step 2 Connect the cables and power on
Connect the processor to the video wall, cameras / NVR, the monitoring network and the commissioning PC. Confirm that the device power LED (PW) is steady on and the network port LED (LINK) blinks normally. After power-on the screen shows the device IP; the IP of the first board is the login IP. Enter this IP when you log in to the device later.
Step 3 Set the PC IP
Set the PC IP to 192.168.168.100, subnet mask 255.255.0.0, default gateway 192.168.168.1. The PC and the processor main control IP (default 192.168.168.200) must be on the same subnet, otherwise the software cannot connect to the device. (After commissioning, restore the PC IP to its original setting to regain internet access.)
Step 4 Log in to the device
Double-click the 【Visual Cloud Management Platform】 icon on the desktop, enter the device IP 192.168.168.200, account admin, leave the password blank, and click “Log in”. (Note: if the device IP has been changed, enter the IP of the first board.)
Step 5 Add signals and put them on the wall
In “Device Management → Signal Data”, add HDMI local signals, monitoring signals or screen capture signals (before adding a monitoring signal, make sure the board IP is on the same subnet as the cameras / NVR). When finished, drag the signal onto the virtual video wall on the right in “Video Wall Management” to display it.
Login troubleshooting (if the device cannot be reached, check in this order)
-
Is the network cable connected: check whether the LINK LED on the device network port blinks, and reseat the cable.
-
Is the subnet the same: the first three octets of the PC IP must match the device main control IP (for example 192.168.168.x).
-
Firewall / antivirus software: temporarily disable the PC firewall and antivirus software, then log in again.
-
Has the device IP been changed: if the board IP was changed on site, log in with the actual IP in use.
Operation levels
General customers can perform these independently: cabling, PC IP configuration, software installation and login, adding signals, putting signals on the wall, subtitles and background images, scene tours, user management, and so on.
Proceed with caution (improper operation may cause abnormal display on the video wall): changing the board IP, output mapping, output cropping / rotation, chip initialization. Before doing so, be sure to read the “Caution” notes in the corresponding chapter and back up the configuration.
Contact the manufacturer for: a forgotten login password, device hardware failure, firmware upgrade exceptions, etc.
Did this page help you?One line of feedback helps us keep the steps accurate.