Skip to main content

The Platform Does Not Show the Device, or Sites Cannot Reach Each Other

Two kinds of problem: the gateway cannot get onto the platform, or devices are online but cannot reach each other.

Decide which kind you have first, then work through the items.

A. The platform does not show the device​

  • 启用(Enable) is checked in EasyTier
  • The startup method is web 配置(Web configuration)
  • The address format is udp://easytier.gshelp.xyz:22020/account name
  • The account name matches the one registered on the platform exactly, including case
  • Wait 1–2 minutes, then refresh the page

If the format and the account name are both right and it still does not come online, see Connecting the gateway to the platform.

B. Devices are online but cannot reach each other​

Possible causeHow to confirmFix
The subnet proxy is not configuredOpen the device's 编辑(Edit) → 常规配置(General configuration) and check the CIDRConfigure it following Configuring a subnet proxy
The two sites use the same subnetCompare both sides' LAN subnetsChange one side's LAN subnet, then reconfigure the subnet proxy
Access control has only one direction selectedCheck whether both directions are selectedSelect both directions
The bypass router has no endpoint gateway setIs the endpoint gateway the gateway's LAN port IP?Change the endpoint gateway, or add a static route on the upstream router
The local machine's firewall is blockingHave the peer ping this computerDisable the firewall temporarily and try again
The symptom of repeating subnets

Every device is online and the tunnel looks healthy, yet nothing is reachable. When you hit this, suspect repeating subnets first.

What you should see when done
  • The member device status is 在线(Online).
  • Ping works in both directions.

One table to rule them all​

SymptomConfirm firstThen
The platform does not see the device at allWhether EasyTier is enabledRe-enter the address as in Step 3
The device is visible but cannot be added to the networkWhether the device is 在线(Online)Go back to the gateway and check its networking status
It can be added to the network but ping failsWhether both sides use the same subnetChange the subnet and reconfigure the subnet proxy
Ping works but the business system does not openWhether access control covers both directionsSelect both directions
Only some devices are unreachableThe subnet the subnet proxy advertisesAdd the missing subnet

Next → Frequently asked questions