Skip to main content

Preparation: Tools, Environment, and Address Planning

Read this checklist before you go on site. It takes about 15 minutes and saves half the rework.

Tools to bring​

ItemNotes
GatewayPower adapter included
Ethernet cablesTwo or more recommended
Setup computerWindows 10/11 with an Ethernet port
Broadband account and passwordProvided by the carrier; required for bridge mode
Optical modem admin accessNeeded to switch the modem to bridge mode, or ask the carrier to do it

First decide which situation the site is in​

Site situationRecommended access mode
The modem can be set to bridge mode and the broadband account and password are availableBridge mode (the gateway dials up)
The modem is in router mode and is hard to changeSecondary router mode, or bypass router mode
A router or switch already exists and the network structure must not changeBypass router mode

After deciding, read Choosing an access mode to confirm the cost.

Site information sheet​

Fill this in before you go on site. It saves half the rework.

Site nameBroadband accountModem modeLAN subnetGateway LAN IPNotes
Example: Central Street store______Router / Bridge192.168.1.0/24192.168.1.2______
Example: Jiefang Road store______Router / Bridge192.168.2.0/24192.168.2.2______

Subnet planning: no repeats between sites​

Subnets must not repeat between sites

Store A uses 192.168.1.x and store B also uses 192.168.1.x: the tunnel comes up, but the two sides cannot reach each other. Give each site a different third octet: 192.168.1.x, 192.168.2.x, 192.168.3.x.

The subnet proxy advertises only the local site's subnet

Do not take the shortcut of writing 0.0.0.0/0, and do not enter the peer site's subnet.

Common addresses and accounts​

ItemValue
Gateway admin addresshttps://192.168.10.1
Gateway default accountroot
Gateway default passwordadmin
Computer setup subnet192.168.10.x, mask 255.255.255.0
Networking platformhttps://easytier.gshelp.xyz
Server address templateudp://easytier.gshelp.xyz:22020/accountname
Factory defaults follow the device label

Factory defaults may differ between batches. When the label and the table above disagree, the label wins.

Next → Choosing an access mode