Documentation
Getting Started
Installation and Access
Network Configuration
Verification and Maintenance
Quick Start: Connect Two Sites in 10 Minutes
Read this page for a first installation. From unboxing to a successful ping takes about 10 minutes.
- One gateway at each site, already powered
- The broadband account and password for each line at hand
- No duplicate subnets between sites
Bridge, secondary router, or bypass router — follow the one you chose all the way through. Mixing them will never work.
Step 1 — Prepare the tools
The gateway ships with a power supply; bring at least two Ethernet cables, a Windows 10/11 computer for setup, and the broadband account and password. Details: Preparation.
Step 2 — Register a platform account
Open https://easytier.gshelp.xyz and click Register.
Remember this account; you will enter it again in step 5.
Details: Register and sign in to the networking platform.
Step 3 — Choose an access mode and wire it up
Choose the mode first, then wire. Bridge and secondary router connect the gateway WAN port to the optical modem LAN port; bypass router connects the gateway LAN port to the switch. Details: Choosing an access mode.
Step 4 — Sign in to the gateway and configure the network
Set the computer IP address to 192.168.10.x, then open https://192.168.10.1 in a browser.
Account root, password admin.
Details: Signing in to the gateway.
Step 5 — Enable the networking service
In the admin page, open Services → EasyTier and select Enable.
Set the start method to web configuration.
Enter the server address udp://easytier.gshelp.xyz:22020/accountname.
Details: Connecting the gateway to the platform.
Step 6 — Create a network and add the devices on the platform
Sign in to the platform and click Network → Create Network. Add three initial nodes and set their protocols to UDP, TCP, and QUIC respectively. Details: Creating a network on the platform.
Step 7 — Configure subnet proxies and verify
On the platform, configure a subnet proxy for each gateway, advertising only the local site subnet. Then ping the peer site's internal IP address from your computer. Details: Configuring subnet proxies.
- Member devices on the platform show Online
- The peer site's internal IP address responds to ping
Stuck? Look here
| Symptom | Go to |
|---|---|
https://192.168.10.1 does not open | Cannot open the admin page, or no internet after configuration |
| No internet after configuration | Cannot open the admin page, or no internet after configuration |
| Device not visible on the platform | Device missing from the platform, or sites cannot reach each other |
Next → Preparation: tools, environment, and address planning
Was this page helpful?A one-line note helps us make these steps more accurate.